Terug naar blog
Handleidingen 2026-11-16 Abstract Ocean | Tesla & Rivian Accessories | A Texas Co. est 0 weergaven

Rivian R1S Rear Quarter Panel PPF: Coverage & Install Tips

Rivian R1S Rear Quarter Panel PPF: Coverage & Install Tips

A practical guide to the pre-cut rear quarter panel PPF for the Rivian R1S: what it covers, what comes in the box, and how to plan a clean DIY install.

Why the rear quarter panel takes a beating on the R1S

The rear quarter panel on the Rivian R1S sits directly behind the rear wheel, where road debris gets thrown up at speed. That makes it one of the first places you'll notice rock chips and scuffs. A clear protection film (PPF) applied to that area acts as a sacrificial layer, absorbing impacts before they reach the paint.

The Rear Quarter Panel Clear Protection Film for the R1S is a pre-cut kit designed for this exact spot. It's 100% clear and almost invisible once installed, so you keep the factory look while adding a layer of defense.

What the kit includes

Material and finish: what to expect

The film is made with ultra premium self-healing, stain resistant paint protection film. Self-healing means minor swirl marks and light scratches can disappear over time with heat, while the stain-resistant top coat helps keep the film looking clear. Because it's precision cut, you don't need a heat gun or special skills to install it—the shape is already matched to the R1S rear quarter panel.

A sensible install sequence for the pre-cut quarter panel film

The kit is designed for DIY installation, and the precision cutout removes the need for trimming or heat work. The steps below follow the supplied preparation and operating instructions; always refer to the included installation instructions and video for the most accurate guidance.

  1. Clean the panel thoroughly: Wash and dry the rear quarter panel so the surface is free of dirt and debris. A clean surface is critical for adhesion and a smooth finish.
  2. Prepare the slip solution: Fill the supplied spray bottle with water as directed. The soap is already in the bottle, so you just add water.
  3. Apply the film with slip: Spray the panel and the film with the slip solution, then position the pre-cut film on the passenger or driver side. The solution lets you slide it into place before squeegeeing.
  4. Squeegee out the solution: Use the included squeegee to press the film flat and push out air and water from under the film, working from the center outward.
  5. Repeat for the other side: The kit includes cutouts for both passenger and driver sides. Follow the same process for the second side.

What the supplied information does not cover

The kit includes installation instructions and a video, which are your best resource for specific techniques. The supplied product information does not specify drying times, curing periods, or recommended temperatures for installation. If you're unsure about any step, consult the included instructions or a professional installer. Also note that the film is precision cut for the R1S rear quarter panel; it is not a universal sheet, so fit is specific to that vehicle.

Who this kit is for

If you drive an R1S and want to protect the rear quarter panel from rock chips without a full wrap, this pre-cut kit is a practical choice. It's designed for DIY install, so you don't need a heat gun or special skills—just patience and a clean workspace. The included tools (spray bottle and squeegee) mean you can get started without hunting for extra supplies. For owners who prefer a hands-off approach, a professional installer can still use this kit, but the DIY route is clearly supported.

Gerelateerde artikelen

Customer Service
Home
Producten
Winkelwagen
Profiel